Page Four
16. Another shot of the drive hub and octopus and how they mate. Notice both have ramping that match. During reassembly I placed a SMALL amount of lithium grease on the ramps.
17. Below is the octupus and drive hub being inserted into the clutch hub with plates. Notice how the clutch hub has a rear backing for plates so can only be used in one direction. The clutch hub can only accept plates on one side and that side faces away from the engine towards the pressure plate.
18. The plate below is a spacer plate and I had much trouble without it being installed. Notice how it is not as wide as the plates below. I would advise leaving this in place since I have a suspicion it works with the clutch hub.
19. Below are all the plates on the centre hub ready for install.
20. Replace the octupus in the reverse from dissasembly and install onto the drive shaft.
21. Replace the concave washer first and make sure the o'ring is in place.
22. Follow with the second washer which has matches the concave washer and the centre nut.
23. Install centre nut, pushrod, and check all gaskets.
